
Loopback Interface Configuration Command Set Command Reference Guide
512 © 2003 ADTRAN, Inc. 61950860L1-35D
ip unnumbered <interface>
Use the ip unnumbered command to use the IP address assigned to the specified interface for all IP
processing on the active interface. Use the no form of this command to remove the unnumbered
configuration.
Syntax Description
<interface>
Specifies the interface (in the format
type slot/port
) that contains the IP address
to be used as the source address for all packets transmitted on this interface
Valid interfaces include: Ethernet (eth 0/1), virtual frame relay sub-interfaces (fr
1.16), virtual PPP interfaces (ppp 1), and loopback interfaces.
Default Values
By default, all interfaces are configured to use a specified IP address (using the ip address command).
Command Modes
(config-interface)# Interface Configuration Mode required
Valid interfaces include: Ethernet (eth 0/1), virtual frame relay sub-interfaces (fr
1.16), virtual PPP interfaces (ppp 1), and loopback interfaces
Command History
Release 1.1 Command was introduced
Functional Notes
If
ip unnumbered
is enabled on an interface, all IP traffic from the interface will use a source IP address taken
from the specified interface. For example, specifying
ip unnumbered ppp 1
while in the Ethernet Interface
Configuration Mode configures the Ethernet interface to use the IP address assigned to the PPP interface for
all IP processing. In addition, the ADTRAN OS uses the specified interface information when sending route
updates over the unnumbered interface.
Usage Examples
The following example configures the loopback interface (labeled
loop
1
) to use the IP address assigned to
the PPP interface (
ppp 1
):
(config)#
interface loopback 1
(config-loop 1)#
ip unnumbered ppp 1
Komentarze do niniejszej Instrukcji