ADTRAN Stub Routing Dokumentacja Pobierz pdf (Strona 279)

100

101

Command Reference Guide Crypto Map IKE Command Set

set peer <address>

Use the set peer command to set the IP address of the peer device. This must be set for multiple remote

peers.

Syntax Description

Enter the IP address of the peer device. If this is not configured, it implies

responder only to any peer.

Default Values

There are no default settings for this command.

Command Modes

(config-crypto-map)# Crypto Map Configuration Mode (IKE or Manual)

Command History

Release 4.1 Command was introduced

Functional Notes

If no peer IP addresses are configured, the entry will only be used to respond to IPSec requests; it cannot

initiate the requests (since it doesn’t know which IP address to send the packet to). If a single peer IP address

is configured, the crypto map entry can be used to both initiate and respond to SAs.

The peer IP address is the public IP address of the device which will terminate the IPSec tunnel. If the peer IP

address is not static, the ADTRAN product cannot initiate the VPN tunnel. By setting no peer IP address, the

ADTRAN product can respond to an IPSec tunnel request in this case.

Usage Examples

The following example sets the peer IP address of 10.100.23.64:

(config-crypto-map)#

set peer 10.100.23.64

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 567 568

Komentarze do niniejszej Instrukcji

Brak uwag

ADTRAN Stub Routing Dokumentacja Strona 279

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking ADTRAN Stub Routing