ADTRAN Stub Routing Dokumentacja Pobierz pdf (Strona 260)

100

101

IKE Policy Command Set Command Reference Guide

initiate [main | aggressive]

Use the initiate command to allow the IKE policy to initiate negotiation (in main mode or aggressive

mode) with peers. Use the no form of this command to allow the policy to respond only.

Syntax Description

main

Specify to initiate using main mode. Main mode requires that each end of the VPN

tunnel has a static WAN IP address. Main mode is more secure than aggressive

mode because more of the main mode negotiations are encrypted.

aggressive

Specify to initiate using aggressive mode. Aggressive mode can be used when

one end of the VPN tunnel has a dynamically assigned address. The side with

the dynamic address has to be the initiator of the traffic and tunnel. The side with

the static address has to be the responder.

Default Values

By default, initiate in main mode is enabled.

Command Modes

(config-ike)# IKE Policy Configuration Mode

Command History

Release 4.1 Command was introduced

Functional Notes

By using the

initiate

and

respond

commands, you can configure the IKE policy to initiate and respond, initiate

only, or respond only. It is an error if you have both

initiate

and

respond

disabled.

Usage Examples

The following example enables the AOS device to initiate IKE negotiation in main mode:

(config-ike)#

initiate main

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 567 568

Komentarze do niniejszej Instrukcji

Brak uwag

ADTRAN Stub Routing Dokumentacja Strona 260

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking ADTRAN Stub Routing