ADTRAN Stub Routing Dokumentacja Pobierz pdf (Strona 417)

100

101

Command Reference Guide Frame Relay Sub-Interface Config Command Set

bridge-group <group#>

Use the bridge-group command to assign an interface to the specified bridge group. This command is

supported on all Ethernet interfaces, PPP virtual interfaces, and frame relay virtual sub-interfaces. Use the

no form of this command to remove the interface from the bridge group.

Syntax Description

<group#>

Bridge group number (1 to 255) specified using the

bridge-group

command

Default Values

By default, there are no configured bridge groups.

Command Modes

(config-interface)# Interface Configuration Mode

Valid interfaces include: Ethernet (eth 0/1), virtual PPP interfaces (ppp 1), and

virtual frame relay sub-interfaces (fr 1.20).

Command History

Release 1.1 Command was introduced

Functional Notes

A bridged network can provide excellent traffic management to reduce collisions and limit the amount of

bandwidth wasted with unnecessary transmissions when routing is not necessary. Any two interfaces can be

bridged (Ethernet to T1 bridge, Ethernet to frame relay sub-interface).

Usage Examples

The following example assigns the frame relay sub-interface labeled 1.16 to bridge-group 1:

(config)#

interface frame-relay 1.16

(config-fr 1.16)#

bridge-group 1

1 2 ... 412 413 414 415 416 417 418 419 420 421 422 ... 567 568

Komentarze do niniejszej Instrukcji

Brak uwag

ADTRAN Stub Routing Dokumentacja Strona 417

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking ADTRAN Stub Routing