ADTRAN Stub Routing Dokumentacja Pobierz pdf (Strona 483)

100

101

Command Reference Guide PPP Interface Configuration Command Set

mtu <size>

Use the mtu command to configure the maximum transmit unit (MTU) size for the active interface. Use

the no form of this command to return to the default value.

Syntax Description

<size>

Configures the window size for transmitted packets. The valid ranges for the

various interfaces are listed below:

Ethernet (eth 0/1)

64 to 1500

virtual frame relay sub-interfaces (fr 1.16)

64 to 1520

virtual PPP interfaces (ppp 1)

64 to 1500

loopback interfaces

64 to 1500

Default Values

<size>

The default values for the various interfaces are listed below:

Ethernet (eth 0/1)

1500

virtual frame relay sub-interfaces (fr 1.16)

1500

virtual PPP interfaces (ppp 1)

1500

loopback interfaces

1500

Command Modes

(config-interface)# Interface Configuration Mode required (applies only to IP interfaces)

Valid interfaces include: Ethernet (eth 0/1), virtual frame relay sub-interfaces

(fr 1.16), virtual PPP interfaces (ppp 1), and loopback interfaces.

Command History

Release 1.1 Command was introduced

Functional Notes

OSPF will not become adjacent on links where the MTU sizes do not match. If router A and router B are

exchanging hello packets but their MTU sizes do not match, they will never reach adjacency. This is by

design and required by the RFC.

Usage Examples

The following example specifies an MTU of 1200 on the virtual PPP interface:

(config)#

interface ppp 1

(config-ppp 1)#

mtu 1200

1 2 ... 478 479 480 481 482 483 484 485 486 487 488 ... 567 568

Komentarze do niniejszej Instrukcji

Brak uwag

ADTRAN Stub Routing Dokumentacja Strona 483

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking ADTRAN Stub Routing