ADTRAN Stub Routing Dokumentacja Pobierz pdf (Strona 175)

100

101

Command Reference Guide Global Configuration Mode Command Set

discard list <access list names> dest-policy <access policy name>

All packets passed by the access list(s) entered and destined for the interface using the access

policy listed will be blocked from the router system. This allows for configurations to deny packets

on a specified interface.

nat source list <access list names> address <IP address> overload

All packets passed by the access list(s) entered will be modified to replace the source IP address

with the entered IP address. The overload keyword allows multiple source IP addresses to be

replaced with the single IP address entered. This hides private IP addresses from outside the local

network.

nat source list <access list names> interface <interface> overload

All packets passed by the access list(s) entered will be modified to replace the source IP address

with the primary IP address of the listed interface. The overload keyword allows multiple source IP

addresses to be replaced with the single IP address of the specified interface. This hides private IP

addresses from outside the local network.

nat destination list <access list names> address <IP address>

All packets passed by the access list(s) entered will be modified to replace the destination IP

address with the entered IP address. The overload keyword is not an option when performing

NAT on the destination IP address; each private address must have a unique public address. This

hides private IP addresses from outside the local network.

Before applying an access control policy to an interface, verify your Telnet

connection will not be affected by the policy. If a policy is applied to the interface you

are connecting through and it does not allow Telnet traffic, your connection will be

lost.

Step 4:

Apply the created access control policy to an interface. To assign an access policy to an interface,

enter the interface configuration mode for the desired interface and enter access policy <policy

name>. The following example assigns access policy MatchAll to the ethernet 0/1 interface:

(config)# interface ethernet 0/1

(config-eth 0/1)# access-policy MatchAll

Technology Review (Continued)

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 567 568

Komentarze do niniejszej Instrukcji

Brak uwag

ADTRAN Stub Routing Dokumentacja Strona 175

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking ADTRAN Stub Routing