ADTRAN Tracer TRACER 2 x E1 Instrukcja Użytkownika Pobierz pdf (Strona 75)

Table 4: Channelized E1 and Channelized E1 IQ show interfaces Output Fields (continued)

Level of OutputField DescriptionField Name

detail extensive none(Frame Relay) Statistics about messages sent between the DTE and the DCE:

• Unknown messages received—Number of received packets that do not fall

into any category.

• Asynchronousupdates received—Number of link status peer changes received.

• Out-of-sequencepackets received—Number of packets for which the sequence

of the packets received is different from the expected sequence.

• Keepalive responses timedout—Number of keepalive responses that timed

out when no LMI packet was reported forn392dte or n393dce intervals. (See

LMI settings).

Common statistics

detail extensive none(Frame Relay, displayed only from the DTE) Number of DLCIs configured from

the DCE.

Nonmatching

DCE-end DLCIs

detail extensive none(PPP) Link Control Protocol state.

• Conf-ack-received—Acknowledgement was received.

• Conf-ack-sent—Acknowledgement was sent.

• Conf-req-sent—Request was sent.

• Down—LCP negotiation is incomplete (not yet completed or has failed).

• Not-configured—LCP is not configured on the interface.

• Opened—LCP negotiation is successful.

LCP state

detail extensive none(PPP) Displays the state of the Challenge Handshake Authentication Protocol

(CHAP) during its transaction.

• Chap-Chal-received—Challenge was received but response not yet sent.

• Chap-Chal-sent—Challenge was sent.

• Chap-Resp-received—Response was received for the challenge sent, but

CHAP has not yet moved into the Success state. (Most likely with RADIUS

authentication.)

• Chap-Resp-sent—Response was sent for the challenge received.

• Closed—CHAP authentication is incomplete.

• Failure—CHAP authentication failed.

• Not-configured—CHAP is not configured on the interface.

• Success—CHAP authentication was successful.

CHAP state

detail extensive noneDate, time, and how long ago the interface went from down to up. The format

is Last flapped: year-month-day hour:minute:second timezone(hour:minute:second

ago). For example, Last flapped: 2002-04-26 10:52:40 PDT (04:33:20 ago).

Last flapped

detail extensive noneNumber of CoS queues configured.CoS Queues

None specifiedInput rate in bits per second (bps) and packets per second (pps).Input Rate

None specifiedOutput rate in bps and pps.Output Rate

detail extensiveTime when the statistics for the interface were last set to zero.Statistics last

cleared

Chapter 5: Monitoring Commands

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 127 128

Komentarze do niniejszej Instrukcji

Brak uwag

ADTRAN Tracer TRACER 2 x E1 Instrukcja Użytkownika Strona 75

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking ADTRAN Tracer TRACER 2 x E1