ADTRAN TA 544 Instrukcja Obsługi Pobierz pdf (Strona 144)

Section 5 DLP-14 Total Access 544R System Manual

8. Type Save at the > prompt. This applies all configuration changes and the current connection is lost.

9. At this point, the service provider reconfigures the network to match the unit's new configuration.

10. After the network configuration is complete, the service provider attempts to connect to the unit. If the

connection is successful, deactivate the failsafe timer by selecting S

YSTEM UTILITY >TERMINAL MODE

and typing fstimer stop at the > prompt.

11. If the connection is not successful, wait until the timer expires and the unit will factory default back to

the A

UTO-CONFIG mode. Repeat Steps 4-10 of this DLP.

Follow-up Procedures

Once this procedure is complete, return to the procedure which referred you to this DLP and continue with

the tasks indicated there.

Set the failsafe timer prior to doing the save. Typing save will apply the configuration

changes, and the unit will not be accessible until the network is reconfigured.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 ... 161 162

Brak uwag

ADTRAN TA 544 Instrukcja Obsługi Strona 144