ADTRAN Stub Routing Podręcznik Użytkownika Pobierz pdf (Strona 75)

Table 4: show interfaces Gigabit Ethernet Output Fields (continued)

Level of OutputField DescriptionField Name

detail extensive none(MX Series routers with Trio MPCs only) State of PPPoE duplicate protection:

On or Off. When duplicate protection is configured for the underlying interface,

a dynamic PPPoE logical interface cannot be activated when an existing active

logical interface is present for the same PPPoE client.

Duplicate

Protection

detail extensive noneMaximum number of MPLS labels configured for the MPLS protocol family on

the logical interface.

Maximum labels

detail extensiveNumber and rate of bytes and packets received and transmitted on the specified

interface set.

• Input bytes, Output bytes—Number of bytes received and transmitted on the

interface set. The value in this field also includes the Layer 2 overhead bytes

for ingress or egress traffic on Ethernet interfaces if you enable accounting

of Layer 2 overhead at the PIC level or the logical interface level.

• Input packets, Output packets—Number of packets received and transmitted

on the interface set.

Traffic statistics

extensiveNumber of IPv6 transit bytes and packets received and transmitted on the

logical interface if IPv6 statistics tracking is enabled.

IPv6 transit

statistics

extensiveNumber and rate of bytes and packets destined to the router.Local statistics

extensiveNumber and rate of bytes and packets transiting the switch.

NOTE: For Gigabit Ethernet intelligent queuing 2 (IQ2) interfaces, the logical

interface egress statistics might not accurately reflect the traffic on the wire

when output shaping is applied. Traffic management output shaping might

drop packets after they are tallied by the Output bytes and Output packets

interface counters. However, correct values display for both of these egress

statistics when per-unit scheduling is enabled for the Gigabit Ethernet IQ2

physical interface, or when a single logical interface is actively using a shared

scheduler.

Transit statistics

detail extensiveUnique number for use by Juniper Networks technical support only.Generation

detail extensive noneRoute table in which the logical interface address is located. For example, 0

refers to the routing table inet.0.

Route Table

detail extensiveInformation about protocol family flags. Possible values are described in the

“Family Flags” section under Common Output Fields Description.

Flags

detail extensive none(Unnumbered Ethernet) Interface from which an unnumbered Ethernet interface

borrows an IPv4 address.

Donor interface

detail extensive none(Unnumbered Ethernet) Secondary IPv4 address of the donor loopback interface

that acts as the preferred source address for the unnumbered Ethernet interface.

Preferred source

address

detail extensiveNames of any input filters applied to this interface. If you specify a precedence

value for any filter in a dynamic profile, filter precedence values appear in

parentheses next to all interfaces.

Input Filters

Chapter 5: Monitoring Commands

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 131 132

Komentarze do niniejszej Instrukcji

Brak uwag

ADTRAN Stub Routing Podręcznik Użytkownika Strona 75

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking ADTRAN Stub Routing